EZ-Lam is the first epoxy laminating resin that is specially formulated for model use. The two part, 2:1 mix resin and hardener is blended for use with lightweight fiberglass, carbon fiber, and Kevlar® cloth. Its low viscosity allows it to flow easily into the weave of the cloth. EZ-Lam cures to a hard, high strength gloss finish and sands easily.
- 30 Minute:EZ-Lam 30 has a pot life of 30 minutes at 75 degrees F and is tack free in four hours at that temperature. We recommend that EZ-Lam 30 be used in cold weather (where the room or part cannot be heated to 75 degrees F) so that the resin will cure within 24 hours.
- 60 Minute:EZ-Lam 60 has a pot life of 60 minutes at 75 degrees F and is tack free in nine hours at that temperature. EZ-Lam 60 will provide double the pot life of EZ-Lam 30 in warm conditions (85-95 degrees). It is recommended where extended lay-up time is required. It should not be used when the ambient temperature is below 65 degrees F, unless the part can be heated to 75 degrees F to activate the cure cycle.
- EZ-Lam may be thinned with 91% isopropyl alcohol for applications where lower viscosity is desired.
- 1oz of resin can cover 100 square inches
- Available Sizes: 12oz., 24oz. (pint), 48oz. (quart), 192oz. (gallon)
- Shipping: Domestic Shipping via UPS Ground Only